Each instruction has a one-byte (8-bit) operation codes or opcode. With 8- bit binary opcode, a total of different operation codes can. Intel instruction set. x0, x1, x2, x3, x4, x5, x6, x7, x8, x9, xA, xB, xC, xD, xE, xF. 0x, NOP 1 4 , LXI B,d16 3 10 , STAX B 1 7 , INX B 1 6 –K 1 1 ADDRESSING MODES OF Shown in the following are the sizes of a 5CH This can be verified from the opcode chart given in the previous chapter.
|Published (Last):||24 August 2017|
|PDF File Size:||5.99 Mb|
|ePub File Size:||7.87 Mb|
|Price:||Free* [*Free Regsitration Required]|
Timing Diagram – Microprocessor Course
The color coding on that chart gives a strong indication of the opcode decoder if the 2 msbits are 00 then if the lower 2 bits are 10 then if bit 2 is a 1 then it is an MVI and bits determine which register. I was in opcod foolishness, was desperately trying to separate the opcode into two parts sequentially!
The first byte being 3E in hexadecimal and chrt second byte being 32 in hexadecimal. How does “3E” tell the microprocessor both the information? Store I6-bit result in memory locations H and H. Confused about the binary code for the MVI instruction in the instruction code. In program 1 direct addressing instruction is used, whereas in program 2 indirect addressing instruction is used. Write a program to shift a 16 bit data, 1 bit right.
I am confused as to how exactly the opcode part is converted into machine code. Program to shift a bit data 1 bit left. Subtract the bit number in memory locations H and H from the bit number in memory locations H and H. Two digit BCD number is stored in memory location H.
Post as a guest Name. Write a set of instructions to alter the contents of flag register in Add two 8-bit numbers Statement: The result of both programs will be the same. Terminate program chrat NOTE: That is it has to load data as well as the target register.
Subtract the contents of memory location H from the memory location H and opckde the result in memory location H. I hope my question makes sense lol. The most significant eight bits of the two numbers to be added are in memory locations H and H.
fhart Exchange the contents of memory locations H and H. Or is it that this entire opcode is predefined and you can’t separate the “MVI” and “target register” in the opcode? Please see Ask Question. Sign up using Facebook.
Store 8-bit data in memory
Assume that data is in BC register pair. Write a program to shift an eight bit data four bits right. My book says that it is a two byte instruction where the opcods byte is the opcode and the second is the operand.
Sign char using Email and Password. Read the program given below and state the contents of all registers after the execution of each instruction in sequence. Email Required, but never shown. Assume data is in register C. Store the result in memory locations H and H with the most opxode byte in memory location H. Subtract two 8-bit numbers Sample problem: In Program 1, direct addressing instructions are used, whereas in Program 2, indirect addressing instructions are used.
Add contents of two memory locations Statement: Assume the least significant digit is stored at H.