Toshiba Satellite Pro L L L Inventec PT10SC AMB-A03 .zip. File size: KB. Views: Service manuals, Schematics > Motherboards > Inventec. Download Free. Inventec Harvey 14 CR/HR A Inventec PT10SC A Esquema Elétrico INVENTEC PT10SC A Satellite L Download:

Author: Vikora Voodoogal
Country: Puerto Rico
Language: English (Spanish)
Genre: Finance
Published (Last): 27 May 2010
Pages: 469
PDF File Size: 7.43 Mb
ePub File Size: 18.71 Mb
ISBN: 272-3-71239-929-1
Downloads: 89519
Price: Free* [*Free Regsitration Required]
Uploader: Akinojar

Voltages measured with DC plugged in and laptop off: AF then stops at code The battery is charging?

INVENTEC PS10S_MP_ AMB-A03 Toshiba Satellite PRO L L |

It made me feel I’m dealing rather with a cool friend than an Administrator and Owner of the forum. Y’re right, voltages found pt10sx my digital multimeter are indeed strange!

Maybe try to delete this pin to the ground? I think this signal must be low level. Tested whether replacing with a known good components: This signal should be generated when the ADP It is through this contact output PWM determines that the processor has a normal contact with the case a common ground wire.

And run the laptop on each phase separately. Y’re right it’s 0. Replace the North bridge To throw this laptop in the garbage.


Toshiba Satellite Pro L schematic – INVENTEC PT10SC for 5,52 $

Lap when switched on with DC only, led sequence is the following: If there is, it’s faster to install a known working PWM. Tested Whether Replacing with A Known good components: Try to set socket processor to perform the disconnection of one phase. I got the idea of making my own database for post-codes of working laps, but creating video pass codes this is very interesting so thank you for the recommendation. Does this code error pinpoint any failure? Voltages at G pins: You need to carefully read onventec Datasheet.

To invenyec this laptop in the garbage. If problem is not solved, thereafter.

INVENTEC PS10S_MP_20080123 6050A2170201-MB-A03 Toshiba Satellite PRO L300 L305

This topic can be closed. A resistor divider where the upper resistor is connected to VCC, the lower resistor NTC thermistor is connected to GND, and the center point is connected to this pin and acts as a temperature sensor half bridge.

Will confirm tomorrow after checking a working Toshiba L whether this signal should be normally high or low. Oh, I just realized that you reply to my last post. Toshiba L shuts down after 2 seconds display. Again, check all measurements were made serviceable multimeter: Add Failing Toshiba tested with debug card, code stops at 78 -Bios is InsideH20didn’t find meaning of this code?


If not availablethen ordered. How can we set socket processor to perform disconnection of one phase differently? Who is the manufacturer of the BIOS? I ‘ll agree then, that’ll be pt1s0c best way to solve definitely the issue!!

Toshiba was returned to customer without repair on his request. Doing it for further analysis in the repair. Also, In Schema and Manual I dont see any indication!

Thank you for your good support. Any suggestion as where to dig further should be of a great help! So in the future will be easier.

Still try to disable one of the phases.